This article mainly introduces:

Argentina hydraulic cylinder,magnetic ring induction cylinder manufacturer,magnetic ring induction cylinder

(Argentina magnetic ring induction cylinder,produced by Hengyu Hydraulic Cylinder Factory）

magnetic ring induction cylinder are widely used in Argentina，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed magnetic ring induction cylinder for customers from Argentina.

Introduction to magnetic ring induction cylinder:

The quality of the magnetic ring induction cylinder can not be ignored in the purchase of the magnetic ring induction cylinder. The magnetic ring induction cylinder is the main component of the magnetic ring induction cylinder, the single pillar for mining, the hydraulic support, the gun tube and other products, and its processing quality directly affects the life and reliability of the entire product. magnetic ring induction cylinder processing requirements are high, its internal surface roughness requirements are Ra0.4 ~ 0.8μm, the coaxiality, wear resistance requirements are strict. The basic feature of magnetic ring induction cylinder is deep hole processing, which has always troubled the processing personnel.

magnetic ring induction cylinder seal leakage causes and countermeasures: a. Loose tie rod nut will cause leakage, tighten the tie rod nut according to the torque requirements of tie rod nut, test no leakage can continue to use. b. Pressure exceeding the limit will also cause leakage. Replace the magnetic ring induction cylinder seal and re-tighten the tie rod nut to reduce the pressure to the nominal pressure range of the magnetic ring induction cylinder. c. The magnetic ring induction cylinder seal is extruded, if the O-ring is obviously extruded at the magnetic ring induction cylinder seal, replace the magnetic ring induction cylinder seal.

When the magnetic ring induction cylinder is in use, once the seal and guide support ring are found to be defective, the seal with the same structural form and appropriate material should be replaced according to the structural form of the magnetic ring induction cylinder seal to be repaired, so as to minimize the thickness of the oil film between the seal and the sealing surface and reduce the leakage of the seal.

The pressure of the sliding surface of the magnetic ring induction cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the magnetic ring induction cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

Answers to some questions about magnetic ring induction cylinder:

What is the reason for the hydraulic cylinder sticking out and not retracting?
There are two reasons: First, the problem with the seal, if there are two seals on the piston, the top seal is broken. Second, when the hydraulic pressure itself is designed, the rod cavity area is too small, so that the desired return force can not be achieved during the return trip. You can first check whether the coupling is damaged; Then see if the relief valve in the oil line block is blocked. If the use time is too long, it needs to be cleaned, the hydraulic oil is very dirty and can block oil block. Electromagnetic directional valves can also be checked, but the chance of problems is relatively small, unless there is a product problem.

When does the cylinder rotate?
The piston rod inside the multistage plunger cylinder can be rotated, and it will rotate when it is subjected to tangential force.