This article mainly introduces:
UAE hydraulic cylinder,servo cylinder manufacturer,servo cylinder
(UAE servo cylinder,produced by Hengyu Hydraulic Co., Ltd）
servo cylinder are widely used in UAE，because of excellent fatigue and impact resistance，no need for deceleration device，long service life.So our company has designed servo cylinder for customers from UAE.
Classification of servo cylinder: according to the mode of movement it can be divided into linear reciprocating movement type and rotary swing type; According to the effect of liquid pressure, it can be divided into single acting type and double acting type. According to the structure, it can be divided into piston type, plunger type, multistage telescopic sleeve type, pinion and rack type, etc. According to the installation form can be divided into rod, earring, foot, hinge shaft and so on; According to the pressure grade can be divided into 16Mpa, 25Mpa, 31.5Mpa and so on.
The difference between the integral servo cylinder and the split servo cylinder: The integral servo cylinder and the split servo cylinder in the servo cylinder are two different servo cylinders, and they are very different. The whole servo cylinder, which is cast in one body, is not prone to problems such as oil leakage; The split servo cylinder is welded twice, so if it is not handled well at the welding, it is prone to problems such as oil leakage and servo cylinder damage. Therefore, it is obvious that the answer to this question is for difference.
The servo cylinder is not the same as the servo cylinder, because the pressure of the pneumatic system is generally within the range of 0.2-1.0Mpa, the servo cylinder can not be used as a high-power power component, but the servo cylinder can be used as a relatively large power component, or the servo cylinder system can be used.
The assembly work of the servo cylinder has a great impact on the quality of the servo cylinder: each part must be carefully cleaned before assembly; To correctly install the sealing device everywhere: when installing the sealing ring, pay attention to its installation direction to avoid oil leakage due to installation, and its lip should be equipped with a pressure oil chamber. In addition, because it is a YX-shaped sealing ring, it is necessary to pay attention to distinguish between shaft and hole use, do not install wrong; Because the sealing device is matched with the sliding surface, an appropriate amount of hydraulic oil should be applied during assembly; The special wrench should be used when the threaded coupling is tightened, and the torque should meet the standard requirements; After the piston and piston rod are assembled, it is necessary to measure whether the coaxiality and straightness on the full length are out of whack. After assembly, there should be no blocking sensation and uneven resistance when the piston assembly moves.
How to calculate the hydraulic cylinder pressure, how much pressure can put up how much weight?
There is a formula for air pressure, hydraulic pressure, water pressure: F=P×S type: f-cylinder or hydraulic cylinder output, unit is Newton (N) P- pressure, unit is Mpa S- effective area, unit is square millimeter (mm2), note: is the effective area, in the hydraulic cylinder to subtract the cross-sectional area of the piston rod.
How to set up the one-way cylinder hydraulic system?
Single acting oil cylinder, that is, an oil cylinder with an oil port, can use two three-way valves to control the cylinder action. The three oil ports are respectively connected to P (oil pump), A (oil cylinder), and T (oil tank). If the oil pump is to run continuously, an electromagnetic relief valve can be added. When the cylinder is not moving, the relief valve can unload the oil pump. You can also add a three-way four-way valve, the middle function is unloaded, two outlets: A connected to the fuel tank, B connected to the cylinder.
Add Wechat