This article mainly introduces:

Malaysia hydraulic cylinder,roller press hydraulic cylinder manufacturer,roller press hydraulic cylinder

(Malaysia roller press hydraulic cylinder,produced by Hengyu Hydraulic Co., Ltd）

roller press hydraulic cylinder are widely used in Malaysia，because of no transmission clearance，simple structure and reliable operation，excellent temperature resistance.So our company has designed roller press hydraulic cylinder for customers from Malaysia.

Introduction to roller press hydraulic cylinder:

When the oil pressure of the roller press hydraulic cylinder inlet is too low to reach the specified value, the leakage situation of the relevant oil system should be checked and the leakage should be eliminated; Check the piston and piston rod seal ring for damage, aging, loose and other phenomena; Check whether the hydraulic pump and pressure valve are faulty.

When the roller press hydraulic cylinder is in use, ensure that the roller press hydraulic cylinder and the surrounding environment should be clean. The tank should be sealed to prevent contamination. Pipelines and fuel tanks should be cleaned to prevent falling off the oxide sheet and other debris. Clean with lint-free cloth or special paper. Twine and binder should not be used as sealing materials. Hydraulic oil according to the design requirements, pay attention to the change of oil temperature and oil pressure. When there is no load, unscrew the exhaust bolt for exhaust.

When the roller press hydraulic cylinder is in use, measures should be added to prevent the intrusion of pollutants. Effective measures should be taken to control the intrusion of pollutants, such as installing high-efficiency air filters in the tank breathing holes, new oil must be filtered, etc., but also must improve the anti-pollution ability of the roller press hydraulic cylinder itself. In the seriously polluted environment, it is more important to pay attention to, such as the underground oil roller press hydraulic cylinder should use fluorine rubber (FRM) and nitrile rubber (NBR) dust ring, and the ground mechanical roller press hydraulic cylinder should use nitrile rubber dust ring; The filter device is added to the oil inlet of the roller press hydraulic cylinder of the dump truck, construction machinery, work platform and other equipment, and in order to reduce the oil inlet resistance, the flow area should be increased as much as possible, which can effectively reduce the particle pollution from the system.

Most of the failure of the roller press hydraulic cylinder is because there is a foreign body in the roller press hydraulic cylinder into the failure of the roller press hydraulic cylinder, the most problematic is that it is difficult to determine when the foreign body is into the roller press hydraulic cylinder. After a foreign body enters, if the outer side of the sliding surface of the piston is equipped with a seal with a lip edge, then the lip edge of the seal can scrape the foreign body when working, which is beneficial to avoid scratching. However, the piston equipped with 0-shaped sealing ring has a sliding surface at both ends, and foreign bodies are sandwiched between this sliding surface, which is easy to form scars.

Answers to some questions about roller press hydraulic cylinder:

How to use a solenoid valve to control the expansion of a cylinder? Doesn't the solenoid valve only control on/off?
Use the solenoid valve P into A-B (generally equipped with oil circuit board) to connect the oil inlet interface at both ends of the cylinder, and the solenoid valve can be realized by power off (refer to the solenoid valve 2B2L, different solenoid valve actions are different).

What are the main dimensions of the cylinder?
The main dimensions of the cylinder include: cylinder inner diameter, piston cylinder diameter, cylinder length, cylinder wall thickness, stroke, installation distance, etc.